This "Ride" is designed to traverse level ground, but all pieces are set to remain in place if you teraform below them. It is possible to have the terminals at different heights, but you would need to raise/lower by incriments of 7 "Ride Height" units (7 Snaps).
Tutorial:
First - Pause the game, then place one of the Terminal Loops:
To that, add the matching Terminal connection:
Continue adding spans- either a slope to go higher or a level to go across:
The Level sections cover only half the standard distance- use the rotate button (Z) to turn the Level section around and attach to the previous placing:
Add a Terminal to each end- there are two types: 1 (with motor) & 2 (without). Use the terminal of the same ride type for propper speed and height of the parts:
Add your towers. There are 3 standard sizes that are interchangeable between the different SkyWay themes, and more parts are available in the second menu: Vodhin's SkyWay Accessories
You can raise the ground around the terminals and add a pathway so it looks like peeps are coming and going (Peeps DO NOT ride this set- it is scenery only).
Several designs for the SkyWay base platforms are available. Chose your favorite and place so the edge of the sloping front is where the cars enter and exit.
Any Span with "Slope 2" in it might look funny when you first place it, due to the steep angle of the cable.
A special "Compression Train" part can be found in the SkyWay Kit Accessories to top the towers properly:
[ 本文章最後由 JOPHY 於 2008-3-7 10:36 編輯 ]
